Haltech S4 Hall Effect Sensor Instrukcja Użytkownika Pobierz pdf

S3 and S4 Hall Effect SensorInstallation and Setup Procedure

E.2.3 Hall Effect Sensors The Haltech hall effect sensor is a two channel device that can be used to trigger the Haltech range of ECU’s in a wide ran

Identifying the magnets poles If you need to identify the magnet poles this can be done easily with the use of a multimeter. By powering up the sen

Typical set-ups - S3 4 cylinder / 2 rotor engine For a four cylinder 2 magnets are required in total, positioned exactly 180° apart. Fi

8 Cylinder For an eight cylinder 4 magnets are required in total, positioned exactly 90° apart. Figure 3: Typical 8 cylinder applicat

The S4 Hall Effect Sensor The S4 sensor which is identified by a grey cable gland operates in the following way: As a south pole passes the senso

Figure 5: Typical 6 cylinder/ 3 rotor application 8 Cylinder For an eight cylinder 5 magnets are required in total positioned exactly 90 ° apart.

E.3 Synchronisation Events Synchronisation Events (Sync Events) are required for sequential and direct fire systems. The Sync Event gives the ECU in

HALTECH S3 / S4 HALL EFFECT SENSOR 4 PIN CONNECTORHALTECH S3 / S4 HALL EFFECT SENSOR 4 PIN CONNECTORS3 SENSOR S4 SENSORB

Powiązane modele: S3 Hall Effect Sensor

Brak uwag